Become a leader in the IoT community!
New DevHeads get a 320-point leaderboard boost when joining the DevHeads IoT Integration Community. In addition to learning and advising, active community leaders are rewarded with community recognition and free tech stuff. Start your Legendary Collaboration now!
Alright
for your i2c lines, i am not seeing pull up resistor
it seems the schematic is not complete yet, is it?
Are you using internal oscillator or external oscillator
why is your boot0 pin floating?
no it isn’t
I’m not sure where I should connect the boot0
extarnal oscillator
Alright try and finish it up
consult this: https://deepbluembedded.com/stm32-boot-modes-stm32-boot0-boot1-pins/
also check the datasheet of the device o
the datasheet will give you recommendations for this
Ok I’ll check it out and complete the schematic
Thanks a lot for the help @afuevu_
you are welcome
CONTRIBUTE TO THIS THREAD