New DevHeads get a 320-point leaderboard boost when joining the DevHeads IoT Integration Community. In addition to learning and advising, active community leaders are rewarded with community recognition and free tech stuff. Start your Legendary Collaboration now!
Hello @hereI’m designing a board with computer vision capability around an ESP32-S3.Also with 4G(LTE) connectivity. I want to use SIM A7670c chip for the connectivity. I need help to implement […]
I am working on a boost converter to step up DC voltage from 12v to 450v. My switching frequency is 45khz on each channel of the sg3525. I am using […]
Hi guys, how can I properly measure the current consumption of the microcontroller on my STM32 Nucleo-64 evaluation board (NUCLEO-L073RZ)? The manual instructs me to remove the JP6/IDD jumper and […]
Hello, Got a uart-to-rs485 converter board from the AliExpress . Its schematic is very close to this one It has a 120ohm resistor at data lines however it is not […]
I want to design a charger that charges my lifepo4 battery(4s,3p). The charger is going to be AC to Dc charger having an output of 14.6v 15Amps. My challenge now […]
Hi there, right now I am planning to make a device which can detect a heart attack by using MAX30102 After a small research, I found out that a heart […]
Hello, all. I am doing a project in which I need to measure DC voltage up to 40V. I know that I could do a simple voltmeter using 2 resistors […]
hello devs, still based on my project parking assistance system using a BeagleBone Black running Embedded Linux, VL53L0X time of flight distance sensor to detect the distance to nearby objects […]
Hi friends, I need assistance implementing a low-power mode to extend battery life for the ATmega2560 with Zephyr OS, and resolve the issue of failing to wake up from low-power […]
