New DevHeads get a 320-point leaderboard boost when joining the DevHeads IoT Integration Community. In addition to learning and advising, active community leaders are rewarded with community recognition and free tech stuff. Start your Legendary Collaboration now!
My latest WIP, the “World’s Second Smallest MIDI Controller” (I think). It’s a bit bigger than the first iteration https://www.youtube.com/watch?v=5Ws_JfCw5NY in order to accommodate a potentiometer and larger buttons, as […]
I am currently utilizing an STM32G431KB board that differs from other boards in the STM32 Nucleo series as it has a wired SWO. While setting up SWV printf on a […]
This is a vacuum suction motor from vacuum robot that am trying to interface with Raspberry Pi. It has 4 wires and am not able to get it working. Any […]
Working on a project trying to measure multiple switch inputs via a single DAC in an R-2R resistor configuration. Took me a while to realize that the inputs needed to […]
I’m looking industrial grade rugged TFT LCD display – 5 to 7 inch. Which should withstand -20 to 85°C, Hazardous environments. Interface – HDMI, PoE preferred. Non-Touch Anyone recommend some […]
Question: has anyone experimented with the serial port on the Arduino Opta? On the Uno et al there are pins broken out as Rx and Tx, but I’m not sure […]
Came up with some code for a project I’m working on that is able to read two buttons for each analog input (and tell if two have been pushed) based […]
Hello Guys, I am working on Mic module which is used with beaglebone, The circuit gonna used in robust Industry environment. Recommend me good microphone (ICs) module circuit with noise […]
