New DevHeads get a 320-point leaderboard boost when joining the DevHeads IoT Integration Community. In addition to learning and advising, active community leaders are rewarded with community recognition and free tech stuff. Start your Legendary Collaboration now!
Hello @here, I have a product I and my team have to develop from scratch. I have from Dec 16, 2024, to Febuary 17, 2025, to get a working prototype. The product is in the EV sector. It is basically a motorcycle, so yeah, a two-wheeler. We are to design and develop the motor controller in-house which is the first step. We intend to use a BLDC motor for this product. I am still going through the requirements and breaking it down, first thing I intend to set up is the pwm driver for the 3-phase system and we will go from there. I will appreciate the community input as we go forward. To an extent i will be sharing design files and firmware, but unfortunately, I won’t be able to share some things. I will appreciate any suggestions and design tips from us @here as we will be moving forward
I started designing this motor controller and using stm32f103c8t6 and bare metal to set up the registers, I started up with generating 3 signals which are 120 degrees apart, my scope only has 2 channels so I couldn’t have the 3 channels on the scope. If I had known when purchasing the scope I would have just gone for 4 channels.<:8637blabbering:1140055047187746857> I had to send the signal through a low pass filter(no calculation was done, which I have to do) and that is what is observed on the scope, I am going to hook it up to Mosfet driver TLP350 and send the signals to drive the mOSFET.
0discord1.mp4
CONTRIBUTE TO THIS THREAD