New DevHeads get a 320-point leaderboard boost when joining the DevHeads IoT Integration Community. In addition to learning and advising, active community leaders are rewarded with community recognition and free tech stuff. Start your Legendary Collaboration now!
Am working on a a home automation system that controls water pumps and taps based on motion detection using the Zephyr RTOS on an ESP32 microcontroller, how can i properly […]
Still based on my project on home automation system that controls water pumps and taps based on motion detection using the Zephyr RTOS on an ESP32. How can i properly […]
I am working on reading temperatures from multiple DS18B20 sensors connected to a shared 1-Wire bus on an STM32 NUCLEO-F103RB board. The sensors operate in parasitic power mode, with a […]
How do I set up and establish communication between the ESP32 and the R307 fingerprint sensor, ensuring that the sensor can be recognized and initialized by the ESP32? My aim […]
I’m programming an STM32 NUCLEO-F207ZG board and trying to output a PWM signal on pin PE_9 (D6) to drive an LED. I’m using low-level register programming (no HAL/LL drivers). However, […]
I currently face a situation where I have to use Google Test for C-Code. So I am not really able to use gmock to mock C-modules. What I want to […]
Hey guys, I’m using an AVR microcontroller with Zephyr to read data from an ADC via SPI. I’ve configured the SPI peripheral and device tree, but the data coming back […]
Looking for some help with getting Clock output on MCO1 (PA8) from LSE here’s a snippet of what I am doing. My logic analyzer gets no pulse from the LSE. […]
Hey guys, a friend of mine is currently working on AT91SAM9M10-EKES. The Code registers IRQ for 2 GPIO pins (PA20 & PA21) but only receives 22/26 expected interrupts (random). Could […]
