New DevHeads get a 320-point leaderboard boost when joining the DevHeads IoT Integration Community. In addition to learning and advising, active community leaders are rewarded with community recognition and free tech stuff. Start your Legendary Collaboration now!
Am working on a smart car automation system using MicroPython, the system include various functionalities such as `obstacle detection`, `line following`, `speed control`, and `environmental monitoring`. Am currently trying to […]
I’m programming an STM32 NUCLEO-F207ZG board and trying to output a PWM signal on pin PE_9 (D6) to drive an LED. I’m using low-level register programming (no HAL/LL drivers). However, […]
Has anyone worked with the kalman filter from the DSP library for ESPs?
I’m working with the STM32 Nucleo L476RG board and the X-Nucleo IDB05A1 expansion board to develop Bluetooth Low Energy applications. My development environment is Keil uVision5, and I’ve successfully built […]
Hello guys, I’m working on a flight controller using an mpu6050 and I’m wondering if the pitch and roll fluctuate too much. These values represent the output of a complementary […]
I’m working on a project to control a display using an 8-bit parallel RGB interface with the Nucleo-F411RE, requiring a 1 MHz PCLK. Since the STM32F411RE lacks LTDC peripherals, I […]
I am using AVR128DA48 microcontroller to control an LED in serial communication. The way I set it up is not complex; I’m sending *‘ON’* and *‘OFF’* commands from a `python` […]
I am using the VL53L0X sensor with an STM32F103C8 microcontroller and want to communicate with the sensor directly over I2C without using ST’s library. My goal is to minimize project […]
Hey guys I noticed a significant increase in power consumption by my IoT devices (ESP32) when transmitting data to AWS IoT Core, leading to shorter battery life. I’ve optimized my […]
