New DevHeads get a 320-point leaderboard boost when joining the DevHeads IoT Integration Community. In addition to learning and advising, active community leaders are rewarded with community recognition and free tech stuff. Start your Legendary Collaboration now!
Hello guys, Recently, I have been building a tracked robot that moves autonomously (avoiding obstacles, etc.). I bought new components that I soldered onto my prototyping board. Before coding, I […]
I am trying to design an automatic water filling system for my coffee machine. I need to design and make two non-contact non-immersion level sensors for the water tank. Ideally […]
Hi, I bought a kit on Amazon that I’m trying to control with an ESP8266. I’ve successfully uploaded the code to the ESP8266 and can monitor the readings from a […]
Has anyone ever got the CH224K to work correctly? For some reason it doesn’t seem to be able to request voltages above 9V. Only 5V and 9V are possible.
I want to know when the batteries of a model are getting low. The 5 AA batteries are over 5 volts so I cannot check the end voltage. I make […]
Latest step in a MIDI drums project: Displaying MIDI inputs to an Arduino Opta w/ an SSD1306 OLED and my AUX adapter device https://www.tindie.com/products/35482 Wasn’t too hard to get the […]
I’m using a circuit that gives a LOW output on D when a magnet passes by the reed switch. Is there a way to make it output HIGH instead? (HIGH […]
Related question: I’ll likely use an ATtiny85 for this project, meaning limited IO pins (WIP schematic pictured). I’ll mostly be listening for signals with a software serial Rx pin, but […]
Those of you that use a CR2032 battery, have you ever looked at the datasheet? Per this one https://www.mouser.com/datasheet/2/315/3627_fileversion-1627278.pdf for instance, using just 2mA drops the capacity significantly in terms […]
