Handling Disconnections in KiCad with Rat Bites and Conductive Screws

Hi, I’ve got a KiCad project (revised 1-inch-midi) that I’ve been working on that involves 3 boards separated by rat bites. Ground, VCC and two signal pins are passed between […]

I want to build a 20A power supply

I want to build a 20A power supply

Is there any founder/maker working on a hardware design which requires high density pcb design ?

Is there any founder/maker working on a hardware design which requires high density pcb design ?

Seeking Feedback on My First ATmega32 Development Board Schematic

i designed this basic atmega32 16 au dev board can anyone , if its fundamentally correct ? its my first schematic that i have build from scratch

PCB Design review. How did I do?

Very new to designing a PCB and want to see how well I’ve done. This is a Mini PCI-e card that is a mixture of the CANable USB module but […]

What’s the major difference between a blind via and a buried via in a PCB design?

What’s the major difference between a blind via and a buried via in a PCB design. And when it’s it good to use it in a design other than using […]

Zero Ohms resistor on the Power Line

Am designing a PCB Board, in the schematics section at the power line, I added a Zero ohms resistor to VBUS power rail for cleaner power. Is adding this value […]