New DevHeads get a 320-point leaderboard boost when joining the DevHeads IoT Integration Community. In addition to learning and advising, active community leaders are rewarded with community recognition and free tech stuff. Start your Legendary Collaboration now!
I am working on reading temperatures from multiple DS18B20 sensors connected to a shared 1-Wire bus on an STM32 NUCLEO-F103RB board. The sensors operate in parasitic power mode, with a […]
I’m programming an STM32 NUCLEO-F207ZG board and trying to output a PWM signal on pin PE_9 (D6) to drive an LED. I’m using low-level register programming (no HAL/LL drivers). However, […]
I am new to STM32WB15CC and am using the STM32WB15CC NUCLEO board. I successfully ran the BLE example `p2pserver` on my board, where the device is discoverable, and I can […]
I’m working with the STM32 Nucleo L476RG board and the X-Nucleo IDB05A1 expansion board to develop Bluetooth Low Energy applications. My development environment is Keil uVision5, and I’ve successfully built […]
I’m working on a project to control a display using an 8-bit parallel RGB interface with the Nucleo-F411RE, requiring a 1 MHz PCLK. Since the STM32F411RE lacks LTDC peripherals, I […]
Hey guys i’m attempting on working on an ESP32 robotic arm control system using FreeRTOS and MQTT, but the system occasionally freezes. I suspect a deadlock between `controlArmTask` and `sendCommandTask`. […]
Looking for some help with getting Clock output on MCO1 (PA8) from LSE here’s a snippet of what I am doing. My logic analyzer gets no pulse from the LSE. […]
Has anyone managed to get printf working with floats on an M4 preferable with cmake and vscode. My cubeIDE works just fine.
I’m building a CNN model to run on an STM32F746NG Discovery board following the “TensorFlow Lite for Microcontrollers” tutorials and the TinyML book. I know that the supported TensorFlow-Keras functions […]
