Join our community of embedded and IoT practitioners to contribute experience, learn new skills and collaborate with other developers with complementary skillsets.
does anyone know how to add DFU in an stm32 bootloader?
Guys I’m trying to implement the SPI in my stm32 Nucleo l476RG without hal drivers. I have have implemented the spi configuration using spi_init function then when it ready for […]
I am using the Arduino IDE to program an STM32 Blue Pill via an ST-Link V2. After following several manuals, I successfully uploaded the blink example to pin C13.Although I […]
I’m working on a project where I want to execute code from internal SRAM on an STM32F103 as an exercise. My goal is to write some THUMB assembly by hand, […]
I’m developing an air quality monitoring system on an `STM32F746` using `TinyML`. The system uses a temperature, humidity, and gas sensor to predict the Air Quality Index (AQI) via a […]
I’m using the STM32 NUCLEO-F401RE microcontroller and have programmed a speaker to change frequency when the joystick is pushed up or down. However, I’m encountering two issues: 1. The frequency […]
I am using an STM32 Nucleo-F446RE with the Ethernet Wiznet W5500 via SPI. The SPI is configured as Master, CPOL = Low, CPHA = 1st Edge, 8-bit data, BaudRatePrescaler = […]
I am working on reading temperatures from multiple DS18B20 sensors connected to a shared 1-Wire bus on an STM32 NUCLEO-F103RB board. The sensors operate in parasitic power mode, with a […]
I’m programming an STM32 NUCLEO-F207ZG board and trying to output a PWM signal on pin PE_9 (D6) to drive an LED. I’m using low-level register programming (no HAL/LL drivers). However, […]
GitHub